Seat rail, I did a bad thing?
Well, I thought I was doing more than enough research at just about every step, and I was going under the premise of remove everything on the inside, clean, treat, etc, and start inner build from scratch. So today I come across someone saying don't remove the seat rail, and I'm like, what?
So ya, I have already removed seat rail and the metal panels underneath. Honestly, they werent that difficult to remove, comparatively, and I didn't think much of it, and lots of the insulation was soggy wet down there.
The panels I removed were flat, not seemingly connected to anything under the floor, other than the thin metal strip along the bottom, held on by small screws.
So, did I really do that much of a bad thing?
(And yes, I have read through now lots of the threads on seat rails, after the fact of course).
(Bus is a 1998 ford Collins 6 window cut away chassis).
|