How do we remove the windows?

[musigenesis]

Originally Posted by Sevier

Do you remember what sealant brand/type you used for the windows? And did you have to seal the screw holes (for example, by putting epoxy on the screw before screwing it in)?

No, the screws I'm talking about are on the inside and don't need sealant (they're the screws with the big round washers around them that hold in both adjacent windows).

I use Dynatron-550 for sealant and highly recommend it. Cheapest place for single tubes is Autozone ($15 ea.) or you can get cases of 12 for $150 or so (you will probably use that much and more - I'm easily over 20 tubes already).

[Sevier]

Originally Posted by musigenesis

No, the screws I'm talking about are on the inside and don't need sealant (they're the screws with the big round washers around them that hold in both adjacent windows).

I use Dynatron-550 for sealant and highly recommend it. Cheapest place for single tubes is Autozone ($15 ea.) or you can get cases of 12 for $150 or so (you will probably use that much and more - I'm easily over 20 tubes already).

Okay, so bus window anatomy is:
Where window meets the bus - bottom
Where window meets the bus - two sides
Corners that seem to have large gaps where water comes in
Edges of the outer sill
Gaskets

So, what do you think of this procedure:
Where window meets the bus - bottom: Butyl tape
Where window meets the bus - two sides: Dynatron-550
Corners that seem to have large gaps where water comes in: Dynatron-550
Edges of the outer sill: Dynatron-550
Gaskets: Dynatron-550

Or .... Ive seen others suggest 3M OEM grade automotive seam sealer or 3M urethane sealer for the corners and vertical ??