Quote:
Originally Posted by Tyania
I know it must be somewhere on the forum but I couldn't find it...
What is the general consensus on using screws to patch the bolt and floor screw holes and then grinding them down just above the end of the heads.
Seems like an easy fix but I haven't noticed any mention of it. Is there an obvious reason that I am not seeing?
|
Well ECCB would tell you to use JB Weld ..
I'm leaving the plywood down so on this one occasion I'll squirt silicone sealant.
One good solution is simply to epoxy pennies over the holes.
Some weld patches over the larger holes, and weld shut the small ones
I'd avoid anything that requires yet more grinding.