Crlefley

This post is for you. So, I finished (almost) fabricating the lower deck. Did get the crane mounted. Then it was time for the BURGOLA...

Can't wait for the Burgala!

I see! So your hinge point is essentially the center (walkway). How do you “stow” your panels in the down position? What locks them...

Sorry, I don't take photos! Here's a short video of some of us Crown Coach Junkies leaving Buses Gone Wild VII for some hooning around...

I used macropoxy 646. It’s a sherwin williams two part coating - I work in oil and gas and they use it to seal metal piping and tanks...

John, Do you have any photos of this setup? Im assuming your panels/framing are mounted the "long way" along the roof. 250watt panels? I...

I have 2kW of tiltable panels hinged to a central walkway, with four panels each side. The walkway runs between the two roof hatches...

Great stuff @Bjorkinman. What did you seal the seams with (the paint on your first initial pictures post roof raise). Thanks!

I have done the hammer method many times friend. Works like a charm.

Oh, to clarify, I put a 3/8" grade 5, I think 1" thread length up through the hat channel and tightened it with a home made lock nut on...

This is great info. Ive toyed around with the strut option, but believe ill be better suited with some 1" or 1.5" square stock to...

@Rucker I am fortunate that my roof is steel. But I think ill be going the route of @Mr P and poking studs through to check my nylock...

Coming back to this thread because unfortunately I missed your question earlier. My panels are about 36x50 inches. They have six panel...

I was thinking of something similar. Especially the fact of pushing the stud up through the roof as opposed to the bolt head being on...

Not to thread jack, But I am in the process of deciding how to mount my panels as well. Im thinking of L brackets. Ive also considered...